Ошибки Kyocera FS1200
- Code: E0
- Description: Communication error
Communication between the engine controller and the main controller is failed. - Causes: • Controller gate array defect • Connector failure between the engine and the main controller • Overrun in the engine system, deactivating the progam flash ROM
- Code: E1
- Description: Main motor error
The main motor is overtorqued. - Causes: • Overcurrent in the main motor circuitry due to an axcessive torque • Loose connector • Defective gate array on the engine board • No response from the main motor due to the defective motor driver (transistor)
- Code: E2
- Description: Laser scanner motor error
The polygon motor does not deliver a synchronous output (L) within the predetermined period of time. - Causes: • Timeout in the predetermined period of lead time which the scanner motor speed has to be reached at start up (SCRDY*) • Connector insertion error • Defective gate array on the engine board • Time out dur to the defective scanner motor driver (transistor)
- Code: E3
- Description: Laser beam detection error
Beam detection is failed. The photo detector board does not deliver a synchronous output (L). - Causes: • No beam hit due to the laser diode defect (PD*) • Improper connector insertion • Soiled/defective beam detector (pinphoto diode) sensor • Defective safety lock • Unoperative gate array input port
- Code: E4
- Description: Fuser heater error
The fuser heater is not intact due to disconnection or the circuit failure. - Causes: • Blown-out thermistor • Improper connector insertion • Blown-out halogen heater • Blown-out thermostat • Comparator defect on the engine board • Defective engine CPU (input port) • Defective gate array (input/output port operation)
- Code: E5
- Description: Eraser error
The eraser is blown out or the power supply does not reach to the eraser - Causes: • Blown-out LED chip(s) • Connector insertion error • Defective gate array (input/output port)
- Code: E6
- Description: Flash ROM error
Checksum is erroneous with the flash ROM. - Causes: • Data readout error on the flash ROM
- Code: E9
- Description: Toner motor error
The toner motor is overtorqued - Causes: • Overcurrent in the toner motor circuitry due to an axcessive torque • Loose connector • Defective gate array on the engine board • Defective toner motor overcurrent detector
- Code: F0
- Description: Front control panel error
Communication is failed between the front panel and the main controller. - Causes: Replace the main controller board.
- Code: F1
- Description: System ROM error
Checksum is failed with FLASH ROM on the main controller board. - Causes: Replace the main controller board.
- Code: F2
- Description: Main memory error
Checksum is failed with the RAM on the main controller board - Causes: Replace the main controller board.
- Code: F3
- Description: General failure
Miscellaneous failure with the main controller, other than F0, F1, and F3, above. - Causes: Turn printer power off, then on again. If not solved, replace the main controller board.