Ошибки Kyocera FS1500
- Code: —
- Display: Paper feed unit open
- Description: The cassette is open in the option paper feeder.
- Code: —
- Display: Top cover Open
- Description: Interlock (SW2 on KP-373/418 [AC] board) is open.
- Code: —
- Display: Opt. feeder 1 (2) rear cover Open
- Description: The rear cover of the frist (second) option feeder is open.
- Code: —
- Display: Developer unit connection error
- Description: The developer connector is loose or not connected.
- Code: —
- Display: Replace Toner kit TK-12 feeder.
- Description: Toner in the developer has been exhausted and the toner concentration in the developing powder is not restorable. The printer does not operate when this message is displayed.’c
- Code: —
- Display: Missing Toner container
- Description: Toner container is not installed.
- Code: —
- Display: Paper jam
- Description: Paper is jammed inside the printer. Depending on the part of the printer at which jam has occurred, one of the feed or stack indicators flashes; Ready indicator flashes; and ATTENTION lights. After the jam is removed, the printer automatically prints the same page again unless the paper was caught before or in the fuser unit.
- Code: —
- Display: Remove manual feed paper
- Description: Paper exists on the manual feed tray while the paper source is envelope feeder.
- Code: —
- Display: IC-CARD error insert again
- Description: The IC card is accidentally removed while rereading.
- Code: —
- Display: Insert the same IC CARD
- Description: The wrong IC card was inserted, following the IC-CARD error/insert again message.
- Code: —
- Display: Memory overflow .. Press ON LINE
- Description: The total amount of the data received by the printer exceeds the printer’s internal memory.
- Code: —
- Display: Print overrun .. Press ON LINE
- Description: The data transferred to the printer was too complex to print on a page.
- Code: —
- Display: Add paper
- Description: The paper cassette is empty or not mounted, or manual feed mode is activated but no paper is present in the manual feed tray.
- Code: —
- Display: Warning low toner TK-12
- Description: The toner supply in the developer is being exhausted. The printer will stop printing after several ten pages of printing.
- Code: —
- Display: Warning Short memory
- Description: The printer’s internal memory is running out due to too many macros and fonts downloaded.
- Code: E0
- Display: Call service person E0
- Description: Engine communication error. The engine controller won’t respond to the command sent by the system via the dual port RAM in approx. 1.2 seconds.
- Code: E1
- Display: Call service person E1
- Description: Main Motor Error. The pulse signal is not detected.
- Code: E4
- Display: Call service person E4
- Description: Fuser Heater Error.
- Code: E5
- Display: Call service person E5
- Description: Eraser Error. The eraser current is less than 15mA (normally 65 mA).
- Code: E6
- Display: Call service person E6
- Description: Engine ROM check sum error.
- Code: E9
- Display: Call service person E9
- Description: Toner Motor Error. The toner motor current is 120 mA or more for one second (normally 30 mA).
- Code: EE … EF
- Display: Call service person EE/EF
- Description: Drum Heater Error/Total Page Counter Error.
- Code: F1
- Display: Call service person F1
- Description: System Checksum Error. An error is detected in the controller. The Ready-symbol and ON LINE indicators go off; and ATTENTION lights. The printer does not operate when this message is displayed.
- Code: F2
- Display: Call service person F2
- Description: Main RAM Error.