Ошибки Kyocera TASKalfa 180
- Code: A0410
- Description: Document processor communication problem Communication fails five times succes-sively.
- Causes: Document processor installed incorrectly.
Defective PWB - Remedy: Document processor installed incorrectly. Check the installation state of the document processor and adjust it if it is not properly installed.
Defective PWB. Replace the main/engine PWB or DP driver PWB and check for correct operation.
- Code: C0150
- Description: Backup memory device problem (engine EEPROM)
Reading from or writing to EEPROM cannot be performed - Causes: Defective main/ engine PWB.
Device damage of EEPROM. - Remedy: Defective main/ engine PWB. Replace the main/engine PWB and check for correct operation.
Device damage of EEPROM. Contact the Service Administrative Division.
- Code: C0610
- Description: Bitmap (DIMM) problem
There is a problem with the data or address bus of the bitmap DRAM. - Causes: Defective main/ engine PWB.
DIMM installed incorrectly.
Defective DIMM. - Remedy: Defective main/ engine PWB. Replace the main/engine PWB and check for correct operation.
DIMM installed incorrectly. Check if the DIMM is inserted into the socket on the main/engine PWB correctly.
Defective DIMM. Replace the DIMM and check for correct operation.
- Code: C3100
- Description: Scanner carriage problem
The home position is not correct when the power is turned on or at the start of copying using the table. - Causes: Poor contact in the connector terminals.
Defective home position switch
Defective scanner motor
The mirror frame, exposure lamp, or scanner wire is defective
Defective main/ engine PWB. - Remedy: Poor contact in the connector terminals. Check the connection of connector YC5 on the main/engine PWB and the connector on the home position switch, and the continuity across the connector terminals. Repair or replace if necessary.
Defective home position switch. Replace the home position switch.
Defective scanner motor. Replace the scanner motor.
The mirror frame, exposure lamp, or scanner wire is defective. Check if the mirror flames and exposure lamp are on the rail. And check the scanner wire winds correctly.
Defective main/ engine PWB. Replace the main/engine PWB and check for correct operation.
- Code: C6000
- Description: Fuser heater break
The temperature does not reach 70 °C/ 158°F in 15 s before secondary stabilization.
Temperature rise of 1°C/1.8°F does not occur in 5 s before secondary stabilization (except during printing). - Causes: Poor contact in the fuser thermistor connector terminals.
Fuser thermistor installed incorrectly.
Fuser thermostat triggered.
Fuser heater installed incorrectly.
Broken fuser heater wire. - Remedy: Poor contact in the fuser thermistor connector terminals. Reinsert the connector. Also check for continuity within the connector cable. If none, remedy or replace the cable.
Fuser thermistor installed incorrectly. Check and reinstall if necessary.
Fuser thermostat triggered. Check for continuity. If none, replace the fuser thermostat.
Fuser heater installed incorrectly. Check and reinstall if necessary.
Broken fuser heater wire. Check for continuity. If none, replace the fuser heater.
